Global-machinery-company VEC156-AU User Manual download pdf (Page 12)

Replacing the DC fuse plug

The fuse in the DC plug (10) protects the charging circuit of the

DC Recharge Adapter. If the AC recharger operates but the DC

charging adapter does not, then the fuse may be opened. To

replace the fuse:

1. Unscrew the end cap of the

DC Plug.

2. Remove spring center contact

and fuse.

3. Check fuse with a continuity

checker.

4. If blown, locate replacement

fuse with same type and rating

(0.5A)

5. Replace the fuse, spring,

contact and end cap.

6. Screw end cap clockwise

until it is finger tight.

DO NOT OVER-TIGHTEN

7. Check for proper operation of

DC Charger Adapter.

Maintenance

Store the spotlight, instruction manual and where necessary the

accessories in the original packaging.

In this way you will always have all the information and parts

ready to hand.

Do not throw used batteries into fire or water. There is a danger

of explosion! Please hand in non-working or used batteries, or

tools with built-in batteries, to the environmentally-safe disposal

unit at a municipal waste-disposal centre, or to your dealer.

Important. All batteries lose charge over time, especially when

they are warm. AC recharge is recommended every two months,

when not in frequent use. Use the AC recharger and charge for

the recommended time.

If the unit has dirt on it, gently clean the outer surfaces of the

spotlight unit with a soft cloth moistened with a mild solution

of water and detergent. Periodically inspect the condition

of recharge adapters, connectors, and wires. Replace any

components that may have become worn or broken.

1 2 ... 7 8 9 10 11 12 13 14 15 16

No comments

Global-machinery-company VEC156-AU User Manual Page 12